Danfoss vlt FC 102 Operating Guide

9 Appendix
9.1 Symbols and Abbreviations
°C
Degrees Celsius
°F
Degrees Fahrenheit
AC
Alternating current
AEO
Automatic energy optimization
AWG
American wire gauge
AMA
Automatic motor adaptation
DC
Direct current
EMC
Electro-magnetic compatibility
ETR
Electronic thermal relay
f
M,N
Nominal motor frequency
I
INV
Rated inverter output current
I
LIM
Current limit
I
M,N
Nominal motor current
I
VLT,MAX
Maximum output current
I
VLT,N
Rated output current supplied by the drive
IP
Ingress protection
LCP
Local control panel
MCT
Motion control tool
n
s
Synchronous motor speed
P
M,N
Nominal motor power
PELV
Protective extra low voltage
PCB
Printed circuit board
PM motor
Permanent magnet motor
PWM
Pulse width motor
RPM
Revolutions per minute
Regen
Regenerative terminals
T
LIM
Torque limit
U
M,N
Nominal motor voltage
AQ267037536117en-000101 / 130R0083116 | Danfoss A/S © 2023.09
Appendix
VLT HVAC Drive FC 102
Operating Guide

Danfoss vlt FC 102 Specifications

General

Category	DC Drives
Model	Danfoss VLT FC 102
Output voltage range	0 to rated motor voltage
Power range	0.37 kW to 200 kW
Communication interfaces	RS-485
Protection features	Overvoltage, undervoltage, overcurrent, short circuit, earth fault, overtemperature, motor thermal protection
Cooling method	Air-cooled
Enclosure rating	IP20, IP21, IP55 (depending on model)
Approvals	CE, UL, cUL