Danfoss vlt soft starter mcd 500 - Page 5

6.6 Displays
53
6.6.1 Temperature Monitoring Screen (S1) 54
6.6.2 Programmable Screen (S2) 54
6.6.3 Average Current (S3) 54
6.6.4 Current Monitoring Screen (S4) 54
6.6.5 Frequency Monitoring Screen (S5) 54
6.6.6 Motor Power Screen (S6) 54
6.6.7 Last Start Information (S7) 54
6.6.8 Date and Time (S8) 54
6.6.9 SCR Conduction Bar Graph 55
6.6.10 Performance Graphs 55
7 Programming
56
7.1 Access Control
56
7.2 Quick Menu
56
7.2.1 Quick Set-up 56
7.2.2 Application Set-up Examples 57
7.2.3 Loggings 58
7.3 Main Menu
58
7.3.1 Parameters 58
7.3.2 Parameter Shortcut 58
7.3.3 Parameter List 59
8 Parameter Descriptions
60
8.1 Primary Motor Settings
60
8.1.1 Brake 61
8.2 Protection
61
8.2.1 Current Imbalance 62
8.2.2 Undercurrent 62
8.2.3 Instantaneous Overcurrent 62
8.2.4 Frequency Trip 62
8.3 Inputs
63
8.4 Outputs
64
8.4.1 Relay A Delays 64
8.4.2 Relays B and C 64
8.4.3 Low Current Flag and High Current Flag 65
8.4.4 Motor Temperature Flag 65
8.4.5 Analog Output A 65
8.5 Start/Stop Timers
66
8.6 Auto-Reset
66
8.6.1 Auto-Reset Delay 67
Contents Operating Guide
MG17K602 Danfoss A/S © 05/2016 All rights reserved. 3