Dascom 1330 - Page 46

Tally Dascom 1330
31
Paper Setup
Valid Settings
Function
Tear
Auto,Manual,
View,Auto@FF
Auto: Form Feed command from the host
causes the printer to advance the paper to the
tear-off position. Printing resumes on the TOF
on next page.
Manual: After the completion of a print job,
press a panel key to advance the paper to the
tear-off position.
View: No incoming print data in 1~2 seconds
after printing completed causes the printer to
advance the paper by 2 lines. Printing
resumes 2 lines below the torn edge.
Auto@FF: In this setting, a formfeed
command is necessary to auto feed the form
to tear position.
Paper End
Detect
No, Yes
No: The printer stops printing if out of paper.
Yes: The printer continues printing even out
of paper.
Compress
Disable, 11:8.2, 13.6:8.2,
Auto
Disable: No compression on the print line
exceeding the printable width.
Auto: The print squeezes an over-width print
line (not exceeding 22" in contents) to the
printable width.
Other Compression Ratio: For example, a
ratio of 11: 8.2 commands the printer to take
this line compression ratio.
**Remark: The compression is disabled after
printer reset or loading a new page.
Paper check
Invalid,Anti-jam,Anti-skew,
Valid
Place the carriage at proper positions to
reduce the chance of paper jam and skew
(effective for cut sheets and continuous
paper).
Invalid: "Anti-skew" and" Anti-jam" are both
invalid.
Anti-jam: After paper is inserted, carriage
moves horizontally from end to end. This
ensures that minor folds on the paper are
ironed out to prevent possible jams.
Anti-skew: After paper is inserted, during the
first few lines of printing, the carriage moves to
the center to apply pressure on the paper to
reduce the chance of paper skew.
Valid: "Anti-skew" and" Anti-jam" are both
valid.