User Guide Menu
61
Top of form pos. 0/60
I
10/60 *
I
60/60
Sets the position of the first printing line. The
factory setting for the first printing position is
10/60" (4,23 mm). This is equivalent to the
second line from the top.
Bottom edge
1)
0/60 *
30/60
Sets the distance between last printing line
and bottom edge.
Line width 80 @ 10 cpi
1)
*
90 @ 10 cpi
94 @ 10 cpi
Sets the line length; unit is number of charac-
ters at a character density of 10 cpi.
If 80 is chosen in Olivetti emulation, 90 is used
for the line length instead of 80.
Left edge 10/90“ *
I
90/90“
Sets the left margin; unit is n/90 inch.
Reference edge Left *
Right
Sets the horizontal leading edge.
Left: the left edge of the character matrix is ali-
gned to the the left edge of the document.
Right: the right edge of the character matrix is
aligned to the right edge of the document.
Continuous Print Off *
On
Selects the handling of paper when the vertical
position exceeds the form length.
MENU
CONTROL
Media Cut Sheet *
H. Binding
V. Binding
Specifies the media type.
Select H. Binding if you want to print
passbooks with horizontal binding, V. Binding
for passbooks with vertical binding.
Cut Sheet: 400 cps max
H. Binding: 300 cps max
V. Binding: 300 cps max
Impact 1, 2, 3, 4, 5, 6*, 7, 8 Selects the impact strength of the print head
for printing on cut sheets. This ensures that
single or copy paper produces optimum
results.
6: for single-ply paper.
7: for 2- or 3-ply paper
8: for 4-ply paper and above
Speed Auto *
Normal
High
Auto: depends on the settings of MEDIA
Normal: 300 cps
High: 400 cps
Low noise Off *
On
Switches the low noise function on and off.
1) Only in Epson and IBM emulation
2) Only if MSR-H is installed
3) Only for printer model with second serial interface
Parameter group Parameter Possible settings Description
To Next Page
Loading...
