Operation ■ Running a Job on PSV7000
—26— Data I/O • 096-0461-001G
back
Ending a Run of Taped Devices
When the batch size has been reached:
1. If the EPD Sensor was used, in the Controller Setup Menu, select
Mode, and then press 3 to disable it.
2. Reset the counter to zero (if used) and run out the desired leader
length.
3. Cut the pocket tape and cover.
Replacing a Full Take-Up Reel
1. Leave the job-specified number of empty pockets on the carrier
tape.
2. Cut the carrier tape.
3. Roll carrier tape onto take up reel and remove reel.
4. Install empty take up reel.
5. Continue job.
To Next Page
Loading...
