Data I/O PSV7000 - Ending a Job

Operation ■ Running a Job on PSV7000
—66— Data I/O • 096-0461-001G
back
Ending a Job
To end a job prior to programming the preset number of devices, click
Finish on the Run Window. This completes the current programming
cycle. No more blank devices are picked from the input media, and
all devices in the sockets are removed and placed in the appropriate
output or reject container.
The job can be resumed by selecting it again in TaskLink or LumenX
and clicking Run. AH700 SW will continue the job where it left off
(when Finish was clicked).
Empty the reject bin or tray after ending a job.
Empty the reject bin
whenever it looks full;
there is no ‘Full’ indica-
tor.