AutoLab TF Dispenser Technical Manual – Revision 5
AutoLab TF dispensers Technical Manual TFTMTF / Rev 5.0 / 24
th
May 2006 Page 13 of 150
1-3 Stock Solution Platform
1-3-1 Description of Stock Solution Platform
Solution Bottle
For stock of dye solution and its capacity is 1000 ml.
Bottle cap
The blue barrel-drain lid is used to prevent the solution splash out and fasten injectors.
There is a scraper inside. When the injector is picked out, it can scrape the solution left
on the surface of the injector.
Injector
The injector is used as transport media of solution for dispensing, and it capacity is 60
㏄。
Bottle rack
The bottle rack is for locating solution bottles. One bottle rack can locate 40 bottles。
Bottom plate
This bottom plate is used to place the bottles and fasten the locating board. Each plate
has a draining hole, which is for draining the leftover solution.
Draining hole
This draining hole is used to drain the leftover solution. It has a connector to connect
tube for draining.
To Next Page
Loading...
Need help?
General