1D Symbologies Enter/Exit Programming Mode
Product Reference Guide 159
Code 39 Set Length 1
This feature specifies one of the bar code lengths for Code 39 Length Control
on page 158
. Length 1 is the minimum label length if in Variable Length on
page 158
Mode, or the first fixed length if in Fixed Length on page 158 Mode.
Length includes the bar code’s check, data, an
d full-ASCII shift characters. The
length does not include start/stop characters.
The length can be set from 0 to 50 characters. See
"Set Length 1" on page 302
for more detailed programming instructions.
Select Code 39 Set Length 1 Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Keypad
representing your desired character(s). End by scanning
the EN
TER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save
the entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
02 = Length 1 is 2 Characters
$CC3L1
~
To Next Page
Loading...
