Setup
28 Gryphon™ I GD/GBT/GM4500
Linking the Reader
Link Datalogic Devices to Base
Before configuring the interface it is necessary to link the handheld with the
base.
To link the handheld and the base simply put it into the base. If the reader was
pre
viously linked to another base, you must first scan the Unlink bar code
before re-linking to the new base.
Unlink
Link Scanner as Serial Device to a Bluetooth Host
Use this procedure to let the scanner communicate with a Bluetooth host using
the Bluetooth Serial Port Profile (SPP).
1. If using a Bluetooth adapter on the host
device, install any driver provided
with the adapter.
2. Scan the Link to Host in SPP mode label below
to make the scanner visible
to the host device.
3. Use the Bluetooth manager of the host device to “Discover new devices”
and s
elect "GBT4500...". If you receive an error message, it may be neces-
sary to change the security settings on either the host device or the scan-
ner.
4. Use an RS-232 terminal program to see
incoming data on the port desig-
nated by the Bluetooth manager of the host device.
Link to Host in SPP mode
To Next Page
Loading...
