Setting Up the Reader
Product Reference Guide 13
Setting Up the Reader
Follow the steps below to connect and get your reader up and communicating
with its host.
1. Configure the Base Station starting on page 18.
2. Link to the Base Station on page 28.
3. Select the Interface Type on page 30.
NOTE
According to recent modification of Regulati
on for shipping Li-Ion based
battery packs, the products and their spare battery packs parts are shipped
with a very low residual charge (low state of charge).
Hence the needs
* that a new product must be fully rech
arged before starting to use it.
and
* that battery packs of the stocked
products GBT/GM45 and spare battery
pack parts must be periodically recharged: for instance by using a WLC4090
cradle powered up with a 12V Datalogic AC/DC adapter (cod.8-0935) for at
least 30 minutes each 3 months.
To Next Page
Loading...
