RS-232/USB-COM Interfaces Enter/Exit Programming Mode
Product Reference Guide 51
ACK NAK Retry Count
This feature specifies the number of times the scanner retries a label transmis-
sion due to a retry condition. The selectable range is from 1 to 254 retries. A
se
lection of 0 disables the count, and a selection of 255 specifies unlimited
retries. See
"ACK NAK Retry Count" on
page 279 for more detailed program-
ming instructions.
Select ACK NAK Retry Count Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Key-
pad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save
the entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
To Next Page
Loading...
