Datalogic Gryphon I GBT4500 - Intercode Delay

Enter/Exit Programming Mode Intercode Delay
84 Gryphon™ I GD/GBT/GM4500
Intercode Delay
Specifies the delay between labels transmitted to the host for this interface. The
selectable range for this feature is from 0 to 99 seconds. See
"Intercode Delay"
on page 284 for more detailed programming in
structions.
Set Intercode Delay
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from the
Alphanumeric characters in
Appendix D, Keypad
representing your desired char
acter(s). End by scanning
the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
00 = No Wedge Intercode Delay
$CKBID
~