Datalogic Gryphon I GBT4500 - ABC Codabar Dynamic Concatenation Timeout; ABC Codabar Force Concatenation

1D Symbologies Enter/Exit Programming Mode
Product Reference Guide 185
ABC Codabar Dynamic Concatenation Timeout
This parameter specifies the timeout in 10-millisecond ticks used by the ABC
Codabar Dynamic Concatenation Mode. The timeout can be set within a range
of 05 to 255 in 10ms increments. A setting of zero specifies no delay.
Select ABC Codabar Dynamic Concatenation
Timeout Setting
To configure this feature, scan the ENTER/EXIT bar
code above, then the bar code at left followed by digits
from the Alphanumeric characters in
Appendix D,
Keypad
representing your desired character(s). End
by scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
10 = Quiet Interval of 200 ms
ABC Codabar Force Concatenation
When ABC Codabar Concatenation is enabled and Force Concatenation is dis-
abled, both Codabar stand alone labels
and ABC Codabar concatenated labels
are transmitted. When ABC Codabar Concatenation is enabled and Force Con-
catenation is enabled only ABC Codabar
concatenated labels are transmitted
while Codabar stand alone labels are not transmitted.
Force Concatenation has no effect if the ABC Codabar Concatenation is dis-
abled. The Force Concatenation mode has eff
ect both in Static and Dynamic
Concatenation Modes.
DEFAULT
ABC Codabar Force Concatenation = Disable
ABC Codabar Force Concatenation = Enable
$CCBDT
~
$CCBFC00
$CCBFC01