Datalogic Gryphon I GBT4500 Product Reference Guide

Enter/Exit Programming Mode Intercharacter Delay
46 Gryphon™ I GD/GBT/GM4500
Intercharacter Delay
This parameter specifies the intercharacter delay between the end of one char-
acter and the beginning of the next. The delay can be set within a range of zero
(0
) to 990 milliseconds in 10ms increments. A setting of zero specifies no
delay. See
"Label ID: Pre-loaded Sets" on
page 288 for more detailed program-
ming instructions.
Intercharacter Delay = No Delay
Select Intercharacter Delay Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Key-
pad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
00 = No Intercharacter Delay
$CR2IC00
$CR2IC
~

Datalogic Gryphon I GBT4500 Specifications

General

Brand	Datalogic
Model	Gryphon I GBT4500
Category	Barcode Reader
Language	English