Enter/Exit Programming Mode Micro QR Code
240 Gryphon™ I GD/GBT/GM4500
Micro QR Code
Set Length 1
Specifies one of the bar code lengths for Micro QR Code Length Control on page
239
. Length 1 is the minimum label length if in Variable Lengt
h
Mode, or the
first fixed length if in Fixed Length Mode. Characters can be set from 0001 to
0
035 characters in increments of 0001 (pad with zeroes).
See
page 302 for detailed instructions on setting this feature.
Select Micro QR Code Length 1 Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left follow
ed by the digits from the Alphanumeric char-
acters in
Appendix D, Keypad
representing your
desired character(s). End by scanning the ENTER/EXIT
bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save
the entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
0001 = Length 1 is 1 Character
To Next Page
Loading...
