30 Installation (for qualified installers only)
© Travis Industries 4150126 100-01418
Attach the Gas and Electrical Lines Between the Fireplace Modules
After the fireplace is in place and secured to the alignment track, the gas and electrical systems between
the modules may be joined.
Gas Inlet Connection
A 3.5” (87mm) flex connector is shipped attached to the fireplace (see photo below to the left). It
is used to connect the gas lines between modules. Attach the open end of the connector to the
adjoining fireplace (see photo below to the right). Make sure to leak test this connection after gas
is plumbed to the fireplace.
To Next Page
Loading...