16
Section 3
DriveRack
™
the DATA wheel will move you to the Linked module selection. When effect modules are linked, any
changes that you make to any parameter, will be made to the same effect in the other linked channels. For
example, if a change is made to the delay time in the linked post crossover delay module, the change will
take place in all other linked(up to four) output channel delay modules.
• Once you are satisfied with your selections on this page, press the NEXT PAGE button which will move
you to the next page, which will appears as follows:
• Leaving the setting at Linked will apply the same Delay parameter values to both delay modules that are
used in in the pre-crossover position. Switching to Unlinked (rotate Data wheel) will keep DELAY inputs
separate.
• Once you are satisfied with your selections on this page, press the NEXT PAGE button which will move
you to the next page, which will appears as follows:
• Rotate the DATA wheel to select the appropriate crossover module. Note that only valid crossover combi-
nations will be made available.
• If you have selected a crossover with effects, press the NEXT PAGE button which will move you to the
next page, which will appear as follows:
Note: If you have however, selected a crossover which has no effects, the 240/241 will automatically
move to the output routing section.
• At this point, you can use the DATA wheel to select either: Unlink ALL, Link ALL, or Custom. Selecting
“Custom” will allow you to custom edit the post-Crossover effects links including: PEQ, DYN
(compressor/limiter), or Post crossover Delay.
These modules can be accessed and edited by pressing the NEXT PG button, and then pressing (to select)
To Next Page
Loading...
