dbx DriveRack 240 - Page 64

®
DriveRack™ User Manual
54
Appendix A
DriveRack
™
Word length: 24 bits
Latency: 74.9 samples typical
THD + Noise: 0.005% typical at +4dBu, 1kHz, 0dB input gain
Frequency Response: 20Hz- 20kHz, +/-0.5dB
Interchannel Crosstalk: <-100dB at 1kHz
Functions:
Pre EQ
Type: One 31-band Graphic EQ per input channel, or
9 band Parametric EQ per input channel
Both inputs linkable
Range: +/-12 dB range
Pre Delay
Length: 1.0 seconds/channel
Both inputs linkable
Crossover
Type: Wire(1x1, 1x2, 1x3, 1x4) Filter (1x1, 1x2, 1x3, 1x4),
Crossovers: 1x2, 1x3, 1x4, 2x3, 2x4, 2x4(Dual Band)
Filter Type: Butterworth, Bessel, or Linkwitz-Riley
Slope: 6, 12, 18 or 24 dB/octave for Butterworth or Bessel filters
12 or 24 dB/octave for Linkwitz-Riley filters
Post EQ
Type: Parametric
Number: 4 EQ bands per output channel
Range: +/-12 dB range
All 4 channels are linkable
Dynamics
Type: Compressor/Limiter with PeakStopPlus™
Attack/Release: Program Dependent
Linking: All 4 parameters are linkable
Post Delay (Driver Alignment)
Length: 365.32 ms per output channel
All 4 parameters are linkable
Phase Compensation
Number: One per output channel
Amount: 0-360 degrees phase shift
Miscellaneous
Output
GUI: RS-232 interface for computer display and configuration
ROM Upgrade: Flash upgradeable through RS-232
Power Requirements
Watts: 100-240V - 50/60 Hz
35 Watts
Dimensions
Dimensions: Height- 1.75” X Width- 19” X Depth 7.90”
Weight 8 lbs.
Shipping Weight: 9.5 lbs.