Figure 60. Removing the LOM riser card
Next step
Install the LOM riser card.
Installing the LOM riser card
Prerequisite
Follow the safety guidelines listed in Safety instructions.
Steps
1 Orient the LOM riser card to t through the Ethernet connectors or the SFP slot on the system.
2 Press the LOM riser card until the card is rmly seated on the system board connector and the two blue plastic snap hold the LOM
riser card in place.
3 Using a Phillips #2 screwdriver, tighten the screws to secure the LOM riser card to the system board.
100
Installing and removing system components
To Next Page
Loading...
