3 Remove the air shroud.
Step
Disconnect the cooling fan cable connected to the system board connector and lift the fan out holding the blue touch point.
Figure 31. Removing the cooling fan
Next steps
1 Install the cooling fan.
2 Install the air shroud.
3 Follow the procedure listed in After working inside your system.
Installing the cooling fan
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
Steps
1 Holding the blue touch point, place the cooling fan into the cooling fan cage.
2 Route the cooling fan cable and connect it to the connector on the system board.
72
Installing and removing system components
To Next Page
Loading...
