Dell EMC PowerEdge XR2 - Optional IDSDM or Vflash Module; Removing the Optional IDSDM or Vflash Card

Figure 57. Installing expansion card into low prole riser
Next steps
1 If applicable, connect the cables to the expansion card.
2 Install the expansion card riser.
3 If applicable, install air shroud.
4 Follow the procedure listed in After working inside your system.
5 Install any device drivers required for the card as described in the documentation for the card.
Optional IDSDM or vFlash module
The IDSDM or vFlash module combines the IDSDM and/or vFlash features into a single module.
NOTE
: The write-protect switch is on the IDSDM or vFlash module.
Removing the optional IDSDM or vFlash card
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
Steps
1 Locate the IDSDM/vFlash connector on the system board.
To locate IDSDM/vFlash, see the System board jumpers and connectors section.
2 Holding the pull tab, lift the IDSDM/vFlash card out of the system.
96
Installing and removing system components