Figure 74. Installing the left control panel
Next steps
1 Install the air shroud.
2 Install the internal PERC riser.
3 Follow the procedure listed in After working inside your system.
Removing the right control panel
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
NOTE
: Ensure that you note the routing of the cables as you remove them from the system board. You must route the
cables properly when you replace them to prevent the cables from being pinched or crimped.
3 Remove the cooling fan.
4 Remove the internal PERC riser.
5 Remove the hard drive backplane.
Steps
1 Lift the cable latch and disconnect the control panel cable from the system board connector.
Installing and removing system components
113
To Next Page
Loading...
