Figure 16. Installing the bezel lter
Next steps
1 Follow the procedure listed in After working inside your system.
2 If applicable, install the front bezel to the system.
System cover
System cover provides security for the entire system and also helps in maintaining proper air ow inside the system.
Removing the system cover
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
Steps
1 Using a 1/4 inch at head or a Phillips #2 screwdriver, rotate the latch release lock counter clockwise to the unlocked position.
2 Loosen the two captive screws on the top of the system cover.
3 Loosen the thumb screw that secures the back of the system cover to the chassis.
NOTE
: Ensure that the three screws are loosened before lifting the latch to avoid damage to the system cover.
4 Lift the latch till the system cover slides back and the tabs on the system cover disengage from the guide slots on the system.
5 Hold the cover on both sides, and lift the cover away from the system.
58
Installing and removing system components
To Next Page
Loading...
