Steps
1 Disconnect the control panel cable from the system board connector.
2 Using a Phillips #1 screwdriver, remove the screw that secures the control panel to the system.
3 Holding the sides, remove the left control panel assembly away from the system.
Figure 73. Removing the left control panel
Next step
Install the left control panel.
Installing the left control panel
Prerequisite
Follow the safety guidelines listed in Safety instructions.
Steps
1 Route the control panel cable through the side wall of the system.
2 Align the left control panel assembly with the system.
3 Connect the control panel cable to the system board connector.
4 Using Phillips #1 screwdriver, replace the screw that secures the left control panel to the system.
112
Installing and removing system components
To Next Page
Loading...
