Installing the MicroSD card
Prerequisites
Follow the safety guidelines listed in Safety instructions.
NOTE: To use an MicroSD card with your system, ensure that the Internal SD Card Port is enabled in System Setup.
NOTE: If reinstalling, ensure that you install the MicroSD cards into the same slots based on the labels you had marked on the
cards during removal.
Steps
1 Locate the MicroSD card connector on the IDSDM or vFlash module. Orient the MicroSD card appropriately and insert the contact-pin
end of the card into the slot.
NOTE: The slot is keyed to ensure correct insertion of the card.
2 Press the card into the card slot to lock it into place.
Next steps
1 Install the air shroud.
2 Follow the procedure listed in After working inside your system.
LOM riser card
The LOM riser card is a small, removable mezzanine card, which provides the exibility of selecting dierent network connectivity options.
Removing the LOM riser card
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 If installed, remove the expansion card riser.
Steps
1 Using a Phillips #2 screwdriver, loosen the screws that secure the LOM riser card to the system board.
2 Release the two blue side plastic snaps holding the LOM riser card.
3 Hold the LOM riser card by the edges on either side, and lift to remove it from the connector on the system board.
4 Slide the LOM riser card towards the front of the system until the Ethernet connectors or the SFP are clear of the slot in the back
panel.
Installing and removing system components
99
To Next Page
Loading...
