Dell EMC PowerEdge XR2 - Cooling Fans; Removing the Cooling Fan

Figure 30. Installing the internal MiniPERC riser
3 Lift the plunger to lock the riser in place.
Next steps
1 Close the cable guiding latch.
2 Follow the procedure listed in After working inside your system.
Cooling fans
The cooling fans are integrated into the system to dissipate the heat generated by the functioning of the system. These fans provide
cooling for the processors, expansion cards, and memory modules.
The XR2 supports up to six standard fans. The cabled fans are mounted between the drives bay and the system board. Each fan has a
single wire harness that plugs into the fan connectors on the system board (Fan 1 through Fan 6).
Table 31. Fan support matrix for XR2
Front
Storage
PSU type CPU count Fan1 Fan2 Fan3 Fan4 Fan5 Fan6
8 x 2.5 inch Redundant
PSU only
1 Required Required Required Required Required Not required
2 Required Required Required Required Required Required
Removing the cooling fan
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
Installing and removing system components
71