Steps
1 Using a Phillips #2 screwdriver, remove the two screws securing the power interposer board (PIB) to the system.
2 Slide the board towards the front of the system and then lift it out.
Figure 71. Removing a PIB
Next step
1 Install the power interposer board.
Installing power interposer board
Prerequisite
Follow the safety guidelines listed in Safety instructions.
Steps
1 Slide the PIB into place.
2 Using a Phillips #2 screwdriver, tighten the two screws to secure the PIB to the system.
3 Route the cables and connect it to the appropriate connectors on the power interposer board, system board, and hard-drive
backplane.
110
Installing and removing system components
To Next Page
Loading...
