Dell EMC PowerEdge XR2 - Removing the Expansion Card from the Expansion Card Riser

Figure 53. Installing low prole riser left
Next steps
1 Replace the internal MiniPERC riser (applicable to expansion card riser 2).
2 Follow the procedure listed in After working inside your system.
3 Install any device drivers required for the card as described in the documentation for the card.
Removing the expansion card from the expansion card riser
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 If applicable, remove the air shroud.
4 Remove the expansion card riser.
5 If applicable, disconnect the cables from the expansion card.
Steps
1 Lift the expansion card latch out of the slot on the riser (Low prole expansion riser 1) .
2 Hold the expansion card by its edges, and pull the card until the card edge connector disengages from the expansion card connector
on the riser.
Installing and removing system components
93