Dell EMC PowerEdge XR2 - Installing the Intrusion Switch

Figure 33. Removing the intrusion switch
Next steps
1 Installing intrusion switch.
2 Follow the procedure listed in After working inside your system.
Installing the intrusion switch
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove air shroud.
4 Remove internal PERC riser.
Steps
1 Align the intrusion switch with the intrusion switch slot.
2 Slide the intrusion switch until it is rmly seated in the intrusion switch slot.
3 Connect the intrusion switch cable to the connector on the system board.
74
Installing and removing system components