Dell EMC PowerEdge XR2 - Installing the Internal Miniperc Riser

2 Install the internal MiniPERC riser.
Installing the internal MiniPERC riser
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
Steps
1 Using a Phillips #2 screwdriver, tighten the screws that connect the PERC cable to the MiniPERC riser.
Figure 29. Installing the PERC cable
2 Holding the blue touch points, align the slots on the internal MiniPERC riser to the guides on the system.
70
Installing and removing system components