Dell EMC PowerEdge XR2 - Installing a Drive Blank

CAUTION: Mixing drive blanks from previous generations of PowerEdge servers is not supported.
Step
Press the release button, and slide the drive blank out of the drive slot.
Figure 35. Removing a drive blank
Next steps
1 Install a drive or a drive blank.
2 If applicable, install the front bezel.
Installing a drive blank
Prerequisite
Follow the safety guidelines listed in Safety instructions.
CAUTION
: Mixing drive blanks from previous generations of PowerEdge servers is not supported.
Step
Insert the drive blank into the drive slot, and push the blank until the release button clicks into place.
76
Installing and removing system components