Figure 58. Removing the optional IDSDM/vFlash card
NOTE
: There are two dip switches on the IDSDM/vFlash card for write-protection.
Next step
Install the optional IDSDM/vFlash card.
Installing the IDSDM or vFlash module
Prerequisite
Follow the safety guidelines listed in Safety instructions.
Steps
1 Locate the IDSDM or vFlash connector on the system board.
To locate IDSDM or vFlash, see the System board jumpers and connectors section.
2 Align IDSDM or vFlash module with the connector on the system board.
3 Push IDSDM or vFlash module until it is rmly seated in the connector on the system board.
Installing and removing system components
97
To Next Page
Loading...
