Figure 75. Removing the right control panel
2 Using a Phillips #1 screwdriver, remove the screw that secures the right control panel to the system.
Next step
1 Install the right control panel.
Installing the right control panel
Prerequisite
Follow the safety guidelines listed in Safety instructions.
Steps
1 Route the control panel cable through the slot on the system.
2 Align the right control panel with the control panel slot on the system and attach the control panel to the system.
3 Connect the control panel cable to the system board connector and secure it using cable latch.
4 Using Phillips #1 screwdriver, replace the screw that secures the right control panel to the system.
114
Installing and removing system components
To Next Page
Loading...
