Dell EMC PowerEdge XR2 - Processor Settings

Option Description
NOTE: The Memory Operating Mode option can have dierent default and available options based on
the memory conguration of your system.
Current State of
Memory Operating
Mode
Species the current state of the memory operating mode.
Node Interleaving Species if Non-Uniform Memory Architecture (NUMA) is supported. If this eld is set to Enabled, memory
interleaving is supported if a symmetric memory conguration is installed. If the eld is set to Disabled, the system
supports NUMA (asymmetric) memory congurations. This option is set to Disabled by default.
Snoop Mode Species the Snoop Mode options. The Snoop Mode options available are Home Snoop, Early Snoop, and
Cluster on Die. This option is set to Early Snoop by default. This eld is available only when the Node Interleaving
is set to Disabled.
Opportunistic Self-
Refresh
Enables or disables opportunistic self-refresh feature. This option is set to Disabled by default.
Persistent Memory This eld controls Persistent Memory on the system.
Processor Settings
You can use the Processor Settings screen to view the processor settings, and perform specic functions such as enabling virtualization
technology, hardware prefetcher,and logical processor idling.
Viewing Processor Settings
To view the Processor Settings screen, perform the following steps:
1 Turn on, or restart your system.
2 Press F2 immediately after you see the following message:
F2 = System Setup
NOTE
: If your operating system begins to load before you press F2, wait for the system to nish booting, and then
restart your system and try again.
3 On the System Setup Main Menu screen, click System BIOS.
4 On the System BIOS screen, click Processor Settings.
Processor Settings details
The Processor Settings screen details are explained as follows:
Option
Description
Logical Processor
Enables or disables the logical processors and displays the number of logical processors. If this option is set to
Enabled, the BIOS displays all the logical processors. If this option is set to Disabled, the BIOS displays only one
logical processor per core. This option is set to Enabled by default.
CPU Interconnect
Speed
Enables you to govern the frequency of the communication links among the CPUs in the system.
NOTE: The standard and basic bin processors support lower link frequencies.
The options available are Maximum data rate, 10.4 GT/s, and 9.6 GT/s. This option is set to Maximum data rate
by default.
Pre-operating system management applications 35