Figure 78. Installing the system board
Next steps
1 Install the Trusted Platform Module (TPM).
NOTE
: The TPM plug-in module is attached to the system board and cannot be removed. A replacement TPM plug-in
module is provided for all system board replacements, where a TPM plug-in module was installed.
2 Replace the following:
a Internal PERC riser
b Internal USB key (if applicable)
c Connect the IO cable to internal USB port
d IDSDM/vFlash module card
e All expansion cards and risers
f Processors and heat sink modules
g Processor blanks (if applicable)
h Memory modules
i LOM riser card
j Air shroud
3 Reconnect all cables to the system board.
NOTE
: Ensure that the cables inside the system are routed along the chassis wall and secured using the cable securing
bracket.
4 Follow the procedure listed in After working inside your system.
5 Ensure that you:
a If the Service Tag is not backed up in the backup ash device, enter the Service Tag manually.
b Update the BIOS and iDRAC versions.
c Re-enable the Trusted Platform Module (TPM). For more information, see the Replacing the Trusted Platform Module section.
118
Installing and removing system components
To Next Page
Loading...
