EasyManua.ls Logo

Dell EMC PowerEdge XR2 - Page 14

Dell EMC PowerEdge XR2
129 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Table 6. Back panel features of XR2
Item Features Icon Description
1 Serial port Use the serial port to connect a serial device to the system. For
more information about the supported serial port, see the Technical
specications section.
2 iDRAC9 Enterprise port
Use the iDRAC9 dedicated network port to securely access the
embedded iDRAC on a separate management network, see the
Integrated Dell Remote Access Controller User's Guide at Dell.com/
idracmanuals.
3 Ethernet ports (2) Use the Ethernet ports to connect Local Area Networks (LANs) to
the system. For more information about the supported Ethernet
ports, see the Technical specications section.
4 Low prole riser right slot N/A Use the card slot to connect half-height PCIe expansion card on
low prole riser.
5 Low prole riser left slot N/A Use the card slot to connect half-height PCIe expansion card on
low prole riser.
6 Power supply unit (PSU) N/A For more information about the PSU congurations, see the
Technical specications section.
7 Power supply unit (PSU) N/A For more information about the PSU congurations, see the
Technical specications section.
8 LOM riser slot N/A Use the LOM riser slot to connect additional NIC.
9 USB 3.0 port (2) Use the USB 3.0 port to connect USB devices to the system. These
ports are 4-pin, USB 3.0-compliant.
10 VGA port Use the VGA port to connect a display to the system. For more
information about the supported VGA port, see the Technical
specications section.
11 CMA power port N/A The Cable Management Arm (CMA) power port enables you to
connect to the CMA.
12 System identication button Press the system ID button:
To locate a particular system within a rack.
To turn the system ID on or o.
To reset iDRAC, press and hold the button for more than 15
seconds.
NOTE:
To reset iDRAC using system ID, ensure that the system
ID button is enabled in the iDRAC setup.
If the system stops responding during POST, press and
hold the system ID button (for more than ve seconds)
to enter the BIOS progress mode.
14 Dell EMC PowerEdge XR2 overview

Table of Contents

Related product manuals