Home
Dell EMC
Storage
Unity 680/F
Dell EMC Unity 680/F User Manual
5
of 1
of 1 rating
126 pages
Give review
Manual
Specs
To Next Page
To Next Page
To Previous Page
To Previous Page
Loading...
4.
Pull the rail forward until the pins slide into the holes on the front of the rack,
then release the latch to secure the rail in place.
Figure 2
Installing the rails
5.
Repeat for the other rail.
Installation Procedures
14
Unity 480/F, Unity 680/F, Unity 880/F
Installation and Service Guide
13
15
Table of Contents
Table of Contents
3
Additional Resources
7
Chapter 1 Installation Procedures
9
Installation Procedures
9
Before You Begin
10
Hardware Terms
10
Installation Workflow Including Optional Daes
10
Daes
10
Release Information
10
Site and Equipment
11
Preparation
11
Site and Equipment Preparation
11
Unpack the DPE
12
Install the Rails in the Cabinet
13
Dpe
13
Cabinet
13
Record the Product Serial Number from the DPE
13
Install the DPE on the Rails
15
Rails
15
Attach the Storage Processors to the Network
16
Cabinet
16
Network
16
Secure the System in the Cabinet
16
Connect Power to the DPE
17
Install Optional
17
Daes
17
Dpe
17
Power up Optional Daes
18
Install Optional Daes
17
Verify Status Leds
18
Installing the Front Bezel
20
Bezel
20
Connect a Windows-Based Computer to Your Storage System
21
Connect a Windows-Based Computer to Your Storage
21
System
21
Automatically Assigning a Dynamic Storage System Management Port IP Address
22
Manually Assigning a Static Storage System Management Port IP Address
23
Download and Install the Connection Utility Software
23
Address
23
Run the Connection Utility
24
Unpack the (Optional) Disk-Array Enclosures
25
15-Drive DAE Container Contents
25
Unpack the (Optional) Disk-Array
25
Enclosures
25
25-Drive DAE Container Contents
27
Install the Disk Array Enclosure
28
Install 15-Drive DAE
28
Enclosure
28
Install 25-Drive DAE
31
Cabling the DPE to a DAE
35
Cabling the DPE to a
35
Dae
35
Cabling the First Optional DAE to Create Back-End Bus 1
36
Cabling an Expansion DAE to an Existing DAE to Extend a Back-End Bus
37
Cabling the Second Optional DAE to Create Back-End Bus 0
37
Connecting Power to the DAE
38
Chapter 2 Service Procedures
41
Default Chapter
41
Service Procedures
41
Replace a Faulted Disk in the DPE
42
Identifying and Locating the Faulted Part in Unisphere
42
Remove a Faulted 2.5" Disk
42
Install a 2.5" Disk
42
Dpe
42
Verifying the Operation of the New Part in Unisphere
43
Returning a Faulted Part
43
Add a New Disk in the DPE
44
Removing the Front Bezel
44
Remove a Disk Filler Module
44
Dpe
44
Install a 2.5" Disk
45
Verifying the Operation of the New Part in Unisphere
45
Replace a Power Supply
46
Identifying and Locating the Faulted Part in Unisphere
46
DPE Power Supply Leds
46
Remove a Power Supply
46
Supply
46
Install a Power Supply
47
Verifying the Operation of the New Part in Unisphere
48
Returning a Faulted Part
48
Replace an Embedded Module
49
Identifying and Locating the Faulted Part in Unisphere
49
Preparing the SP Assembly for Service
49
Replace an Embedded
49
Module
49
Embedded Module Leds
50
Remove a Faulted Embedded Module
51
Transfer the 4-Port Card
53
Install an Embedded Module
55
Rebooting a SP Assembly into Normal Mode
55
Verifying the Operation of the New Part in Unisphere
56
Add a 4-Port Card
56
Preparing the SP Assembly for Service
56
Remove an Embedded Module
57
Identify the Location for the New 4-Port Card
58
Install a 4-Port Card
58
Install an Embedded Module
59
Adding the 4-Port Card to SP B
60
Rebooting a SP Assembly into Normal Mode
60
Committing the New I/O Ports
61
Verifying the Operation of the New Part in Unisphere
61
Replace a 4-Port Card
61
Identifying and Locating the Faulted Part in Unisphere
61
Card
61
Preparing the SP Assembly for Service
62
Embedded Module Leds
62
Remove an Embedded Module
64
Remove a 4-Port Card
65
Install a 4-Port Card
66
Install an Embedded Module
67
Rebooting a SP Assembly into Normal Mode
68
Verifying the Operation of the New Part in Unisphere
68
Add an SFP
69
Install an SFP Module
69
Committing the New I/O Ports
69
Verifying the Operation of the New Part in Unisphere
70
Replace a Faulted SFP
70
Identifying and Locating the Faulted Part in Unisphere
70
Remove an SFP Module
70
Sfp
70
Install an SFP Module
71
Verifying the Operation of the New Part in Unisphere
71
Returning a Faulted Part
72
Replace an I/O Module
72
Identifying and Locating the Faulted Part in Unisphere
72
Preparing the SP Assembly for Service
72
Module
72
DPE I/O Module Leds
73
Remove a Faulted I/O Module
73
Install a New I/O Module
74
Rebooting a SP Assembly into Normal Mode
75
Verifying the Operation of the New Part in Unisphere
75
Returning a Faulted Part
75
Add an I/O Module
76
Locating a Slot for a New I/O Module
76
Remove a Filler I/O Module
76
Install a New I/O Module
76
Verifying that the New I/O Ports Are Recognized
77
Adding the I/O Module to SP B
78
Committing the New I/O Ports
78
Replace a Fan Module
78
Identifying and Locating the Faulted Part in Unisphere
78
Preparing the Storage Processor (SP) for Service
79
Remove the SP Assembly
80
Remove the Top Cover from the SP Assembly
82
Remove the Faulted Fan Module
83
Install a New Fan Module
84
Install the Top Cover on the SP Assembly
84
Install the SP Assembly
85
Rebooting an SP Assembly into Normal Mode
86
Verifying the Operation of the New Part in Unisphere
87
Returning a Faulted Part
87
Replace a Dual Inline Memory Module (DIMM)
88
Identifying and Locating the Faulted Part in Unisphere
88
Preparing the Storage Processor (SP) for Service
88
Replace a Dual Inline Memory Module
88
(DIMM)
88
Remove the SP Assembly
89
Remove the Top Cover from the SP Assembly
91
Remove the Faulted Dual Inline Memory Module
92
Install the Dual Inline Memory Module
92
Install the Top Cover on the SP Assembly
93
Install the SP Assembly
94
Rebooting an SP Assembly into Normal Mode
95
Verifying the Operation of the New Part in Unisphere
96
Returning a Faulted Part
96
Replace an M.2 SSD
96
Identifying and Locating the Faulted Part in Unisphere
96
Ssd
96
Preparing the Storage Processor (SP) for Service
97
Remove the SP Assembly
98
Remove the Top Cover from the SP Assembly
100
Remove the Faulted M.2 SSD
101
Install the M.2 SSD
102
Install the Top Cover on the SP Assembly
103
Install the SP Assembly
104
Rebooting an SP Assembly into Normal Mode
105
Verifying the Operation of the New Part in Unisphere
106
Returning a Faulted Part
106
Replace an SP Assembly
106
Identifying and Locating the Faulted Part in Unisphere
106
Preparing the Storage Processor (SP) for Service
106
Assembly
106
Remove the SP Assembly
108
Remove the Top Cover from the SP Assembly
110
Transfer Parts from the Faulted SP Assembly to the Replacement SP Assembly
111
Install the Top Cover on the SP Assembly
114
Install the SP Assembly
114
Rebooting an SP Assembly into Normal Mode
115
Verifying the Operation of the New Part in Unisphere
116
Returning a Faulted Part
116
Appendix A Configuration Worksheet
117
Configuration Worksheet Appendix A
118
Configuration Worksheet
118
Appendix B Safety Precautions for Handling Replaceable Units
121
Safety Precautions for Handling Replaceable Units Appendix B
122
Handling Replaceable Units
122
Avoiding Electrostatic Discharge (ESD) Damage
122
Emergency Procedures (Without an ESD Kit)
122
Hardware Acclimation Times
123
Removing, Installing, or Storing Replaceable Units
124
Unpacking a Part
125
Standard Touch Point Colors
125
5
Based on 1 rating
Ask a question
Give review
Questions and Answers:
Need help?
Do you have a question about the Dell EMC Unity 680/F and is the answer not in the manual?
Ask a question
Dell EMC Unity 680/F Specifications
General
Brand
Dell EMC
Model
Unity 680/F
Category
Storage
Language
English
Related product manuals
Dell EMC Unity 480
8 pages
Dell EMC Unity 300
70 pages
Dell EMC Unity 380
70 pages
Dell EMC Unity 400
70 pages
Dell EMC Unity 500
70 pages
Dell EMC Unity 880F
8 pages
Dell EMC Unity 350F
70 pages
Dell EMC Unity 380F
70 pages
Dell EMC Unity 450F
70 pages
Dell EMC Unity 480/F
126 pages
Dell EMC Unity Series
8 pages
Dell EMC ECS U480-E
114 pages
To Next PageTo Next PageTo Previous PageTo Previous Page
Loading...
Need help?
General