Dell EMC Unity 680/F User Manual

Verifying the operation of the new part in Unisphere.....................45
Replace a power supply.............................................................................. 46
Identifying and locating the faulted part in Unisphere....................46
DPE power supply LEDs................................................................ 46
Remove a power supply.................................................................46
Install a power supply.....................................................................47
Verifying the operation of the new part in Unisphere.....................48
Returning a faulted part.................................................................48
Replace an embedded module.................................................................... 49
Identifying and locating the faulted part in Unisphere....................49
Preparing the SP assembly for service.......................................... 49
Embedded module LEDs................................................................ 50
Remove a faulted embedded module..............................................51
Transfer the 4-port card................................................................53
Install an embedded module...........................................................55
Rebooting a SP assembly into Normal Mode................................. 55
Verifying the operation of the new part in Unisphere.....................56
Add a 4-port card....................................................................................... 56
Preparing the SP assembly for service.......................................... 56
Remove an embedded module....................................................... 57
Identify the location for the new 4-port card.................................58
Install a 4-port card....................................................................... 58
Install an embedded module...........................................................59
Adding the 4-port card to SP B..................................................... 60
Rebooting a SP assembly into Normal Mode................................. 60
Committing the new I/O ports....................................................... 61
Verifying the operation of the new part in Unisphere..................... 61
Replace a 4-port card................................................................................. 61
Identifying and locating the faulted part in Unisphere.................... 61
Preparing the SP assembly for service.......................................... 62
Embedded module LEDs................................................................ 62
Remove an embedded module....................................................... 64
Remove a 4-port card....................................................................65
Install a 4-port card....................................................................... 66
Install an embedded module...........................................................67
Rebooting a SP assembly into Normal Mode................................. 68
Verifying the operation of the new part in Unisphere.....................68
Add an SFP................................................................................................ 69
Install an SFP module.................................................................... 69
Committing the new I/O ports.......................................................69
Verifying the operation of the new part in Unisphere.....................70
Replace a faulted SFP................................................................................ 70
Identifying and locating the faulted part in Unisphere....................70
Remove an SFP module................................................................. 70
Install an SFP module..................................................................... 71
Verifying the operation of the new part in Unisphere..................... 71
Returning a faulted part.................................................................72
Replace an I/O module............................................................................... 72
Identifying and locating the faulted part in Unisphere.................... 72
Preparing the SP assembly for service.......................................... 72
DPE I/O module LEDs....................................................................73
Remove a faulted I/O module........................................................ 73
Install a new I/O module................................................................ 74
Rebooting a SP assembly into Normal Mode................................. 75
Verifying the operation of the new part in Unisphere.....................75
Returning a faulted part.................................................................75
CONTENTS
4 Unity 480/F, Unity 680/F, Unity 880/F Installation and Service Guide

Dell EMC Unity 680/F Specifications

General

Brand	Dell EMC
Model	Unity 680/F
Category	Storage
Language	English