Dell PowerConnect 3524P

Configuring System Information 207
Defining LLDP Properties
The LLDP Properties page contains fields for configuring LLDP.
To open the LLDP Properties page, click System
→ LLDP-MED → LLDP Properties in the tree view.
Figure 6-76. LLDP Properties
• Enable LLDP — Indicates if LLDP is enabled on the device. The possible field values are:
–
Checked — Indicates that LLDP is enabled on the device.
–
Unchecked — Indicates that LLDP is disabled on the device. This is the default value.
•
Updates Interval (5-32768) — Indicates that rate at which LLDP advertisement updates are sent.
The possible field range is 5 - 32768 seconds. The default value is 30 seconds.
•
Hold Multiplier (2-10) — Specifies the hold time to be sent in the LLDP update packets as a multiple
of the timer value. The possible field range is 2 - 10. The field default is 4.
•
Reinitializing Delay (1-10) — Specifies the minimum time in seconds an LLDP port will wait before
reinitializing LLDP transmission. The possible field range is 1 - 10 seconds. The field default is
2 seconds.
•
Transmit Delay (1-8192) — Indicates the amount of time that passes between successive LLDP frame
transmissions due to changes in the LLDP local systems MIB. The possible field value is 1 – 8192
seconds. The field default is 2 seconds.