Configuring System Information 157
Configuring DNS Servers Using the CLI Commands
The following table summarizes the CLI commands for configuring device system information.
The following is an example of the CLI commands:
Defining Default Domains
The Default Domain Name page provides information for defining default DNS domain names.
To open the Default Domain Name page, click System → IP Addressing → Default Domain Name.
Figure 6-46. Default Domain Name
Table 6-27. DNS Server CLI Commands
CLI Command Description
ip name-server server-address Sets the available name servers. Up to eight name servers can be set.
no ip name-server server-address Removes a name server.
ip domain-name name Defines a default domain name that the software uses to complete
unqualified host names.
clear host {name | *} Deletes entries from the host name-to-address cache.
show hosts [name] Displays the default domain name, list of name server hosts, the
static and the cached list of host names and addresses.
ip domain-lookup Enables DNS system for translating host names to IP addresses.
console(config)# ip name-server 176.16.1.18
To Next Page
Loading...
