Configuring System Information 99
Displaying Device Versions Using the CLI
The following table summarizes the equivalent CLI commands for viewing fields displayed in the
Versions page.
The following is an example of the CLI commands:
Managing Stack Members
The Stack Management page allows network managers to switch stack control between unit 1 and unit 2
in the stack. To open the Stack Management page, click System
→ General → Stack Management in the
tree view.
Figure 6-8. Stack Management
•
Switch Stack Control from Unit 1 to Unit 2
— Enables switching from the current stack Master to the
backup Master unit.
Table 6-6. Versions CLI Commands
CLI Command Description
show version Displays system version information.
console> show version
Unit SW version Boot version HW version
------------------- ------------------- ------------------- -----
1 1.0.0.8 1.0.0.02 00.00.01
To Next Page
Loading...
