Dell PowerConnect 3524P

358 Configuring Switch Information
• Dynamic — Assigns a port to a VLAN based on the host source MAC address connected to the port.
–
Checked — The port may be registered in a dynamic VLAN.
–
Unchecked — The port is not allowed to register in a dynamic VLAN.
•
PVID (1-4095) — Assigns a VLAN ID to untagged packets. The possible values are 1-4095.
VLAN 4095 is defined as per standard and industry practice as the Discard VLAN. Packets classified to
the Discard VLAN are dropped.
•
Frame Type — Packet type accepted on the port. Possible values are:
–
Admit Tag Only — Only tagged packets are accepted on the port.
–
Admit All — Both tagged and untagged packets are accepted on the port.
•
Ingress Filtering — Ingress filtering discards packets that are destined to VLANs of which the specific
port is not a member.
–
Enable — Ingress filtering is activated on the port.
–
Disable — Ingress filtering is not activated on the port.
•
Current Reserved VLAN — The VLAN currently designated by the system as the reserved VLAN.
•
Reserve VLAN for Internal Use — The VLAN selected by the user to be the reserved VLAN if not in
use by the system.
Assigning Port Settings
1 Open the VLAN Port Settings page.
2 Select the port to which settings need to be assigned from the Port drop-down menu.
3 Complete the remaining fields on the page
4 Click Apply Changes .
The VLAN port settings are defined, and the device is updated.