80 Configuring System Information
•
Unit No.
— Indicates the unit number for which the device asset information is displayed.
•
Service Tag
— The service reference number used when servicing the device.
•
Asset Tag (0-16 Characters)
— Indicates the user-defined device reference.
•
Serial No.
— The device serial number.
Defining System Information
1
Open the
Asset page
.
2
Define the relevant fields.
3
Click
Apply Changes
.
The system parameters are defined, and the device is updated.
Initiating a Telnet Session
1
Open the
Asset page
.
2
Click
Telnet
.
A Telnet session is initiated.
Configuring device Information Using the CLI Commands
The following table summarizes the equivalent CLI commands for viewing and setting fields displayed
in the Asset page.
Table 6-1. Asset CLI Commands
CLI Command Description
hostname name Indicates or modifies the device host name.
snmp-server contact text Sets up a system contact.
snmp-server location text Enters information on where the device is located.
clock set hh:mm:ss day month year Manually sets the system clock and date.
show clock [detail] Displays the time and date from the system clock.
show system id Displays the service tag information.
show system Displays system information.
asset-tag text Sets the device asset tag.
show stack <1-8> Displays the system stack information.
show system [unit unit] Displays system information.
show system id [unit unit] Displays system identity information.
To Next Page
Loading...
