Dell PowerConnect 3524P - Page 96

96 Configuring System Information
Defining PoE Settings
1 Open the Power Over Ethernet page.
2 Define the fields.
3 Click Apply Changes .
PoE settings are defined, and the device is updated.
Displaying PoE Settings for All Ports
1 Open the Power Over Ethernet page.
2 Click Show All .
The
Power Over Ethernet Table opens.
Figure 6-6. Power Over Ethernet Table
Managing PoE Using the CLI Commands
The following table summarizes the equivalent CLI commands for viewing fields displayed on the Power
Over Ethernet page.
Table 6-5. System Health CLI Commands
CLI Command Description
power inline {auto | never} Configures the administrative mode of the inline power on
an interface.
power inline powered-device
pd-type
Adds a description of the powered device type.
power inline priority
{critical | high | low}
Configures the priority of the interface from the point of
view of inline power management.
power inline usage-threshold Configures the threshold for triggering alarms
power inline traps enable Enables PoE device traps
show power inline [
ethernet
interface
]
Displays PoE configuration information