Dell PowerConnect 5424

Configuring System Information 111
3 Complete the fields on the page.
Network Mask specifies the subnetwork mask of the source IP address.
4 Click Apply Changes .
The new interface is added, and the device is updated.
Modifying IP Address Parameters
1 Open the IPv6 Interface page.
2 Select an IP address in the IP Address drop-down menu.
3 Modify the required fields.
4 Click Apply Changes .
The parameters are modified, and the device is updated.
Deleting IP Addresses
1 Open the IPv6 Interface page.
2 Click Show All.
The IPv4 Interface Parameters Table opens:
Figure 6-25. IPv4 Interface Parameter Table
3 Select an IP address and select the Remove check box.
4 Click Apply Changes .
The selected IP address is deleted, and the device is updated.