Dell PowerConnect 5424

Configuring System Information 203
Removing SNMP Groups
1 Open the Access Control Group page.
2 Click Show All . The Access Table opens.
3 Select an SNMP group .
4 Check the Remove checkbox.
5 Click Apply Changes . The SNMP group is deleted, and the device is updated.
Defining SNMP Access Control Using CLI Commands
The following table summarizes the equivalent CLI commands for defining fields displayed in the
Access Control Group page.
The following is an example of the CLI commands:
Assigning SNMP User Security
The User Security Model (USM) page enables assigning system users to SNMP groups, as well as
defining the user authentication method.
To open the User Security Model (USM) page, click System →SNMP → User Security Model in the
tree view.
Figure 6-88. SNMP Access Control CLI Commands
CLI Command Description
snmp-server group
groupname {v1 | v2 | v3
{noauth | auth | priv}} [read
readview ]
[write
writeview ] [notify notifyview ]
Configure a new Simple Network Management
Protocol (SNMP) group, or a table that maps
SNMP users to SNMP views.
no snmp-server group
groupname [v1 | v2 |
v3 [noauth | auth | priv]] [context name]
To remove a specified SNMP group.
console (config)# snmp-server group user-group v3 priv read
user-view