Configuring System Information 125
Defining IPv6 ISATAP Tunnel Parameters Using CLI Commands
The following table summarizes the equivalent CLI commands for setting fields displayed in the IPv6
ISATAP Tunnel page.
The following is an example of the CLI commands:
Defining IPv6 Neighbors
The IPv6 Neighbors Page contains information for defining IPv6 Neighbors which is similar to the
functionality of the IPv4 Address Resolution Protocol (ARP). IPv6 Neighbors enables detecting Link Local
addresses within the same subnet, and includes a database for maintaining reachability information
about the active neighbors paths.
Table 6-21. IPv6 Default Gateway CLI Commands
CLI Command Description
interface tunnel number Enters tunnel interface configuration mode.
tunnel mode ipv6ip {isatap} Configures an IPv6 transition mechanism global support mode.
tunnel isatap router router_name Configures a global string that represents a specific automatic tunnel
router domain name.
tunnel source { auto | ip-address ipv4-
address | interface }
Sets the local (source) IPv4 address of a tunnel interface.
tunnel isatap query-interval seconds Configures the interval between DNS Queries (before the IP address of
the ISATAP router is known) for the automatic tunnel router domain
name.
tunnel isatap solicitation-interval
seconds
Configures the interval between ISATAP router solicitations messages
(when there is no active ISATAP router).
tunnel isatap robustness number Configure the number of DNS Query / Router Solicitation refresh
messages that the device sends.
show ipv6 tunnel Displays information on the ISATAP tunnel.
Console> show ipv6 tunnel
Router DNS name: ISATAP
Router IPv4 address: 172.16.1.1
DNS Query interval: 10 seconds
Min DNS Query interval: 0 seconds
Router Solicitation interval: 10 seconds
Min Router Solicitation interval: 0 seconds
Robustness: 3
To Next Page
Loading...
Need help?
General
