Configuring Device Information 275
Configuring DHCP Snooping Trusted Interfaces with CLI Commands
The following table summarizes the equivalent CLI commands for configuring DHCP Snooping Trusted
Interfaces
.
Adding Interfaces to the DHCP Snooping Database
The DHCP Snooping Binding Database page contains parameters for querying and adding IP addresses
to the DHCP Snooping Database.
To open the Binding Database page, click Switch→ DHCP Snooping → Binding Database
Figure 7-20. Binding Database
Table 7-10.
DHCP Snooping Trusted Interfaces CLI Commands
CLI Command Description
ip dhcp snooping trust
no ip dhcp snooping trust
Use the ip dhcp snooping trust interface
configuration command to configure a port
as trusted for DHCP snooping purposes.
Use the no form of this command to return
to the default setting.
To Next Page
Loading...
