Dell PowerConnect 5424 User Manual

Configuring Quality of Service 423
Mapping a CoS value to a Queue
1 Open the CoS to Queue Mapping Table page.
2 Select a CoS entry.
3 Define the queue number in the Queue field.
4 Click Apply Changes .
The CoS value is mapped to a queue, and the device is updated.
Assigning CoS Values to Queues Using the CLI Commands
The following table summarizes the equivalent CLI commands for configuring fields in the CoS to
Queue Mapping Table page.
The following is an example of the CLI commands:
Mapping DSCP Values to Queues
The DSCP to Queue page provides fields for defining output queue to specific DSCP fields. For the list
of the DSCP default queue settings, see "DSCP to Queue Mapping Table Default Values" on page 412.
To open the DSCP to Queue page, click Quality of Service→ CoS Global Parameters→ DSCP to Queue
in the tree view.
Table 9-7. CoS to Queue Settings CLI Commands
CLI Command Description
wrr-queue cos-map queue-id
cos1..cos8
Maps assigned CoS values to the
egress queues.
Console (config)# wrr-queue cos-map 4 7

Dell PowerConnect 5424 Specifications

General

Ports	24 x 10/100/1000Base-T
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
VLAN Support	Yes
Rack Mountable	Yes
Power Supply	Internal
MAC Address Table Size	8K entries
RAM	128 MB
Flash Memory	16 MB
Voltage Required	100-240V AC
Management	Web, CLI, SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% (non-condensing)
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Remote Management Protocol	SNMP, RMON, Telnet
Features	QoS, VLAN, Link Aggregation