Configuring System Information 139
The following is an example of the CLI commands:
console# enable
console# configure
console (config)# ip host accounting.abc.com 176.10.23.1
Configuring ARP
The Address Resolution Protocol (ARP) is a TCP/IP protocol that converts IP addresses into physical
addresses. The static entries can be defined in the ARP Table. When static entries are defined,
a permanent entry is entered and used to translate IP addresses to MAC addresses. To open the ARP
Settings page, click System→ IP Addressing→ ARP in the tree view.
Figure 6-44. ARP Settings
clear host {name | *} Deletes entries from the host name-to-address cache.
show hosts [name] Displays the default domain name, list of name server hosts, the
static and the cached list of host names and addresses.
Table 6-26. Domain Host Name CLI Commands (continued)
CLI Command Description
To Next Page
Loading...
